1812 2012 2812 parti filtro acqua a membrana da 150 gpd 200 gpd RO Purificatore di acqua fabbrica Prezzo domestico domestico osmosi inversa membrana alta Flusso basso Prezzo

Model No.
HT-TW-2012-200
Codice SA
8421991000
Capacità di Produzione
2400000PCS/Year
Prezzo di riferimento
Vi preghiamo di contattarci per un preventivo
contattaci

Descrizione del Prodotto

                                     TW- 2012 - 200

  1. Testing   Condition   and   Performance
 
Model Pressure  
psi(bar) 		Permeate Flow
GPD(L/H) 		S table Rejection
( % )
TW- 2012 - 200 70(4.8) 200(31.54) 97
a. The flow and rejection are based on following testing condition: 500ppm softened tap water ,t emperature 25°C,pH7.5-8,r ecovery rate 3 5%  and above testing pressure
b. The minimum rejection is 9 6 .0%.
c. One single membrane flow may fluctuate within ±20%

2. M embrane Size
M odel
i nch( mm) 		A B C D E
TW- 2012 - 200 11.74
(298) 		0.875
(22 .2 ) 		0.68
( 17 ) 		1.85
(47±0.5) 		10
( 254 )

3 .  O peration Limits and Condition
Operation Limits M embrane type P olyamide composite membrane
M aximum feed water temperature 45ºC
Maximum   operating   pressure 300 psi( 20.68 bar)
p H Range 2-11
M aximum feed water SDI 15 5
Maximum influent turbidity  /NTU 1
Free chlorine tolerance (mg/L) 0.1

4 . N otice
(1) The first 5 gallons of produced water must be discarded. This initial stage of produced water is not drinkable, nor can it be used as cooking water.
(2) After the initial wetting, the components need to be kept in a wet state forever.
(3) When the system is out of service for a long time, it is recommended to immerse the membrane element in the preservation solution to prevent the growth of microorganisms in the system. Before using again, wash off the preservation solution.
(4) The membrane element still has some tolerance for short-term exposure to chlorine (hypochlorite). However, continuous contact may cause damage to the membrane element, so the above situation should be avoided.










 

 

Membrana Filtrante

PNEUTEC.IT, 2023