Good Quality Welding Wire
GB/T 8110 ER50-2
AWS A5.18 ER70S-2
BS EN 1668-W 38 3 W2Ti
ISO 636-A-W 38 3 W2Ti
ISO 636-B-W 49 A 3 W2
Carbon Steel TIG Welding Wire
Introduction
It is TIG wires for 450 and 500MPa grade carbon steel. Good welding technical performance, all-position welding and beautiful welding performance. It has good crack resistance and higher low temperature impact toughness.
Application
It is mainly used for single pass welding of killed steel, semi-killed steel and rimming steel. No need gas protection at back of joint.
Chemical Composition
C
|
Mn
|
Si
|
S
|
P
|
Cu
|
Ti
|
Al
|
Zrf
|
0.035
|
1.14
|
0.53
|
0.004
|
0.011
|
0.20
|
0.13
|
0.08
|
0.08
|
Mechanical Properties
Tensile Strength Rm (MPa)
|
Yield Strength Rel (MPa)
|
Elongation A(%)
|
-30°C Impact Value AKV (J)
|
550
|
450
|
26
|
85
|
Notes:
-
Protection gas flow requirement: The welding current is 100-200A at air flow of 7-12L/min; It is 200-300A at air flow of 12-15L/min.
-
The extension length of the tungsten electrode should be as short as possible relative to the nozzle, and the arc length should be 1-4mm (2-4mm for welding carbon steel; 1-3mm for low alloy steel and stainless steel welding)
-
It adopts windproof measurement while wind speed is above 1.0m/s.
-
Strictly remove grease, rust and moisture impurities while welding.
-
Welding linear energy directly affects mechanical properties of welding seam metal and crack resistance performance, etc which should be paid more attention to.
-
The above points are taken into reference.
GB/T 8110 ER50-2